# Mike Campbell Pedalboard 2013: Full Gear & Pedal List > The 2013 Mike Campbell pedalboard, pedal by pedal: Camel Toe Triple Overdrive, Whammy II and 4 more. Signal-chain order, settings and cited sources. - Canonical page: https://pedalboardarchive.com/artists/mike-campbell/heartbreakers-touring-board-2013/ - Machine-readable index of the archive: https://pedalboardarchive.com/llms.txt - Evidence and reconstruction conventions: https://pedalboardarchive.com/methodology/ ## At a glance | Field | Value | | --- | --- | | Artist | Mike Campbell | | Board | Heartbreakers touring effects board | | Date | 2013-07-27 — July 27, 2013 (day precision) | | Context | Tom Petty and the Heartbreakers tour rig rundown | | Scope | Exact board snapshot | | Signal path | 6 units · Guitar to amplifier | | Routing | Serial path | | Unit evidence | Documented | | Order evidence | Reconstructed | | Status | Tech-verified inventory · order reconstructed | | Audited | 2026-07-18 | | Sources | 3 | Mike Campbell's 2013 Heartbreakers board is six units: a rare Camel Toe Triple Overdrive, an early black Whammy II, a Line 6 MM4 and DL4, a remotely switched '62 reissue spring reverb unit and a Boss RC-30 looper. ## Signal chain **Order evidence — Reconstructed.** No source publishes this sequence; the order is reconstructed. The units are evidenced; their sequence is the archive's inference from the convention below, not an observation. Do not report this order as documented. Reconstruction convention: Tuner → Wah and filter → Compressor → Overdrive, distortion and fuzz → Modulation → Delay → Reverb → Amplifier. A documented routing zone always overrides it. `Guitar → Camel Toe Triple Overdrive → Whammy II → MM4 Modulation Modeler → '62 Reissue Reverb Unit → DL4 Delay Modeler → RC-30 Loop Station → amplifier` | # | Unit | Role | Zone | Unit evidence | Position evidence | Catalog page | | --- | --- | --- | --- | --- | --- | --- | | 1 | Camel Toe Triple Overdrive | Supplies Campbell's principal louder and more saturated lead level without replacing the small-amplifier character. | Front of amp | Documented | Reconstructed | https://pedalboardarchive.com/pedals/camel-toe-triple-overdrive/ | | 2 | Whammy II | Provides foot-controlled pitch shifts for the songs that require Campbell's programmed interval effects. | Front of amp | Documented | Reconstructed | https://pedalboardarchive.com/pedals/digitech-whammy/ | | 3 | MM4 Modulation Modeler | Provides Campbell's occasional chorus and other song-specific modulation sounds. | Front of amp | Documented | Reconstructed | https://pedalboardarchive.com/pedals/mm4-modulation-modeler/ | | 4 | '62 Reissue Reverb Unit | Adds the separate spring-reverb voice engaged from Campbell's custom remote footswitch. | Front of amp | Documented | Reconstructed | https://pedalboardarchive.com/pedals/62-reissue-reverb-unit/ | | 5 | DL4 Delay Modeler | Provides repeat echoes and stored delay sounds after the gain and modulation effects. | Front of amp | Documented | Reconstructed | https://pedalboardarchive.com/pedals/dl4-delay-modeler/ | | 6 | RC-30 Loop Station | Captures and plays back phrases at the end of Campbell's 2013 floor-effects route. | Front of amp | Documented | Reconstructed | https://pedalboardarchive.com/pedals/rc-30-loop-station/ | ## Reconstruction note Steve Winstead identifies every effect in this 2013 rig, and Campbell independently confirms the Camel Toe, DL4 and MM4 as long-running tools. The published article does not provide a complete jack-to-jack trace, so the displayed order follows a conservative gain, pitch, modulation, reverb, delay and looper grouping and is explicitly reconstructed. The tuner, Green Meanie amplifier selector and reverb footswitch are omitted as control infrastructure; the audio-carrying reverb unit itself remains represented. ## Questions ### What pedals did Mike Campbell use in 2013? This dated entry lists 6 units: Camel Toe Triple Overdrive, Whammy II, MM4 Modulation Modeler, '62 Reissue Reverb Unit, DL4 Delay Modeler, RC-30 Loop Station. This is the recorded inventory, not a claim that every connection or model identification is confirmed; see the evidence and routing notes. ### What order were Mike Campbell's pedals in? The complete order is reconstructed, not observed. The layout follows the cited routing constraints and the archive's signal-chain convention where the sources are silent: Guitar → Camel Toe Triple Overdrive → Whammy II → MM4 Modulation Modeler → '62 Reissue Reverb Unit → DL4 Delay Modeler → RC-30 Loop Station → amplifier. ### Is this Mike Campbell's full guitar rig? No. This dated entry covers 6 units in the effects path, not every piece of gear Mike Campbell owned or used. Floor pedals, rack units and routing devices are included only where recorded; omitted equipment and uncertain connections are explained in the notes. It is not a complete or current rig inventory. ### When and where was this pedalboard used? July 27, 2013. Tom Petty and the Heartbreakers tour rig rundown. This is one dated setup as documented, not a career-wide gear list. ### How does the archive know what was on this pedalboard? 3 cited sources, listed above with the date each was read, including Premier Guitar, Tape Op, Effects Bay. Among them a rig rundown, an interview and a photograph. The units are recorded as documented equipment, and the page was last audited on 2026-07-18. ## Sources 3 cited sources across 3 independent groups. Two sources sharing an independent group report the same observation and count once. 1. [Rig Rundown: Tom Petty and the Heartbreakers' Mike Campbell](https://www.premierguitar.com/videos/rig-rundown/mike-campbell-rig-rundown) — Premier Guitar (Primary source · rig-rundown), published 2013-07-27, accessed 2026-07-18, independent group `steve-winstead-mike-campbell-2013` 2. [Mike Campbell: Dirty Knobs & Heartbreakers](https://tapeop.com/interviews/150/mike-campbell) — Tape Op (Primary source · interview), published 2022-07-01, accessed 2026-07-18, independent group `mike-campbell-first-person-tape-op` 3. [Mike Campbell of the Heartbreakers Interview (DunlopTV)](https://www.effectsbay.com/2010/06/mike-campbell-of-the-heartbreakers-interview-dunloptv/) — Effects Bay (Specialist source · photograph), published 2010-06-22, accessed 2026-07-18, independent group `dunlop-tv-mike-campbell-board-2010` ## Related pages - Every documented board by Mike Campbell: [Mike Campbell board history](https://pedalboardarchive.com/artists/mike-campbell/) - [Nick Zinner — Four-board sampling rig](https://pedalboardarchive.com/artists/nick-zinner/four-board-sampling-rig-2013/): shares DL4 Delay Modeler, MM4 Modulation Modeler, DigiTech Whammy - [David Gilmour — PULSE / Division Bell rig](https://pedalboardarchive.com/artists/david-gilmour/pulse-division-bell-rig-1994/): shares DigiTech Whammy - [Ed O'Brien — Earth tour ten-loop board](https://pedalboardarchive.com/artists/ed-o-brien/earth-tour-loop-board-2020/): shares DigiTech Whammy - [Eric Gales — Crown touring board](https://pedalboardarchive.com/artists/eric-gales/crown-tour-2023/): shares DigiTech Whammy - [J Mascis — Bradshaw-switched touring board](https://pedalboardarchive.com/artists/j-mascis/dinosaur-jr-touring-board-2021/): no shared unit; a comparable signal path (Looping, Reverb & Ambience, Modulation, Delay & Echo, Gain) - [Kevin Shields — Reunion tour three-board switching system](https://pedalboardarchive.com/artists/kevin-shields/reunion-tour-three-board-system-2008/): no shared unit; a comparable signal path (Looping, Pitch & Synth, Modulation, Delay & Echo, Gain) - Previous board in archive order: [Mick Taylor — Two-pedal live rig](https://pedalboardarchive.com/artists/mick-taylor/spring-1998-two-pedal-live-rig/) - Next board in archive order: [Neil Young — Red board and vintage effects rig](https://pedalboardarchive.com/artists/neil-young/electric-tour-red-board-2009/)